i set up the standards checker to check my drawing levels comply with the project dgnlib files
i ran the programme and noticed the same level kept coming up as an error
i deleted the rouge level, compressed & saved settings. on re-entering the rouge level it was back.
the rouge level was not listed as a dgnlib file level
despite that on checking the dgnlib files themselves the rouge level is present in all of them
when i delete the rouge level, compressed & saved settings. the rouge level is back on re-entering the file
i don't know what else to try, any suggestions?
has anyone else had this problem?
i am using Bentley mechanical SS2: 08.11.07.500